Operating Manual

InstallatIon

4: Installation

4.1: Before installation

Connecting the device in a manner inconsistent with this

manual may cause risk to health, life or material damage.

• Connect only in accordance with one of the diagrams,

• The device is powered with secure voltage; nevertheless, the user

should be extra careful or should commission the installation to a

qualied person,

• Do not connect devices which are not compliant with the

specication,

• Every connected device should be compliant with the relevant

safety standards,

• RGBW Controller 2 and the load connected to its output must

be powered by 12VDC or 24VDC stabilized power supply with

short circuit protection. Connecting higher voltage or voltage not

matching the load’s voltage may cause damage to the device,

• Connecting long RGBW/RGB/LED strips may cause voltage drops,

resulting in lower light brightness further from R/G/B/W outputs.

To eliminate this eect it is recommended to connect few shorter

strips in parallel connection instead of one long strip connected

serially,

• RGBW Controller 2 has 0-10V inputs. There is no 0-10V output.

Output is controlled by PWM at 244Hz,

• We recommend using monostable switches for comfortable light

control.

Notes for diagrams:

IN3

IN4

(R)

(G)

(B)

(

)

P(12/24V DC)

GND

IN1

IN2

FIBARO

RGBW Controller 2

OUT1

OUT2

OUT3

OUT4

P – 12/24V DC power supply connector

GND – ground connector