User's Guide

INSTALLATION

#3: Installation

Connecting the Switch 2 in a manner inconsistent with this

manual may cause risk to health, life or material damage.

When connecting the Switch 2 act in accordance with the

following rules:

• Connect only in accordance with one of the diagrams,

• Electrical installation must be protected by overcurrent protection

(fuse) of with a value not higher than 10A,

• The Switch 2 should be installed in a wall switch box compliant with

a relevant national safety standards and with depth no less than

60mm,

• Electrical switches used in installation should be compliant with the

relevant safety standards,

• Length of wires used to connect the control switch should not

exceed 10m.

Notes for the diagrams:

S1 - terminal for 1st switch (has the function of

activating the learning mode)

S2 - terminal for 2nd switch

L - terminal for live lead

Q/Q1 - output terminal of the 1st channel

Q2 - output terminal of the 2nd channel (only

Double Switch 2)

N - terminal for neutral lead

B - service button (used to add/remove the de-

vice and navigate the menu)

QL NS1 S2 L

Q1L NS1 S2

DOUBLE

SWITCH 2

FGS-223

SINGLE

SWITCH 2

FGS-213

Tips for arranging the antenna:

• Locate the antenna as far from metal elements as possible

(connecting wires, bracket rings, etc.) in order to prevent

interferences,

• Metal surfaces in the direct vicinity of the antenna (e.g. ush

mounted metal boxes, metal door frames) may impair signal

reception!

• Do not cut or shorten the antenna - its length is perfectly matched

to the band in which the system operates.