FLOOD SENSOR WATER LEAK & TEMPERATURE SENSOR Quick Start Guide
Scan the code to read the manual Support If you need help configuring the FIBARO Flood Sensor, take advantage of our guides and technical manuals available at: manuals.fibaro.
Package Contents Every Flood Sensor has a unique ID, the HomeKit Setup Code. You will find the setup code on back cover of the Quick Start Guide.
FIBARO app Download FIBARO application from the App Store. homekit.fibaro.
First launch Step 1 Step 2 Open the casing by turning the cover counter-clockwise Take off the cover Fig. 1 Fig. 2 Step 3 Step 4 Remove the battery blocker and check if the battery is placed correctly Close the cover by turning it clockwise Fig. 3 Fig.
First launch Step 5 Step 6 Open the FIBARO app and tap Add accessory icon Application will guide you through the pairing process ! Fig.
First launch Step 7 Place accessory on a surface prone to flooding Fig. 6 Electrodes Resetting the Flood Sensor to factory defaults: 1. Open the cover 2. Press the button 3 times then press and hold the button ! Button Fig. 7 3. When the LED glows yellow, release the button 4. Click the button again immediately to confirm 7 After resetting the accessory will blink red — it is ready to be paired again.
HomeKit Setup Code is needed to securely add accessory to your home. You may need it in case of re-pairing. Remember to keep it in safe place. Nobody but you has a copy. FIBARO cannot recover the HomeKit setup code for you. Room: .......................................... Write down the location of the device. © Fibar Group S.A. All rights reserved Made in Poland www.fibaro.
