Installation Manual

Sensus Installation Manual

150-00006 Rev 5

User and Operator - The terms “user” and “operator” apply to persons other than service

personnel.

Ground(ing) and Earth(ing) - The terms “ground(ing)” and “earth(ing)” are synonymous. This

document uses “ground(ing)” for clarity, but it can be interpreted as having the same meaning as

“earth(ing).”

Electric Shock Hazard

This equipment meets applicable safety standards.

WARNING:

To reduce risk of electric shock, perform only the instructions that are included in the operating

instructions. Refer all servicing to qualified service personnel only.

• Electric shock can cause personal injury or even death. Avoid direct contact with

dangerous voltages at all times. The protective ground connection is essential to safe

operation and must be verified before connecting the power supply.

• Know the following safety warnings and guidelines:

o Dangerous Voltages

▪ Only qualified service personnel are allowed to perform equipment installation or

replacement.

▪ Only qualified service personnel are allowed to remove chassis covers and access

any of the components inside the chassis.

o Grounding

▪ Do not violate the protective grounding by using an extension cable, power cable,

or autotransformer without a protective ground conductor.

▪ Take care to maintain the protective grounding of this equipment during service or

repair and to re-establish the protective grounding before putting this equipment

back into operation.

Federal Communications Commission (FCC) Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used