Installation Manual

Sensus Installation Manual

150-00006 Rev 5

in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

Fiber Mountain has not approved any changes or modifications to this device by the user. Any

changes or modifications could void the user’s authority to operate the equipment. See 47 CFR Sec.

15.21.

FCC ID: 2APNW - SENFG1MA

Innovation, Science and Economic Development Canada (ISED)

Compliance Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,

Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the

following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

IC ID: 23833 - SENFG1MA

Installation Site

When selecting the installation site, comply with the following:

• Protective Ground - The protective ground lead of the building's electrical installation

should comply with national and local requirements.

• Environmental Condition – The installation site should be dry, clean, and ventilated. Do

not use this equipment where it could be at risk of contact with water. Ensure that this

equipment is operated in an environment that meets the requirements as stated in this

equipment's technical specifications, which may be found on this equipment's data sheet.

Installation Requirements

WARNING:

Allow only qualified service personnel to install this equipment. The installation must conform to all local

codes and regulations.