Installation Manual

Sensus Installation Manual

150-00006 Rev 5

Grounding-Type Plug

To properly ground this equipment, follow these safety guidelines:

• For a 3-terminal plug (one terminal on this plug is a protective grounding pin), insert the

plug into a grounded mains, 3-terminal outlet.

Note: This plug fits only one way. If this plug cannot be fully inserted into the outlet,

contact an electrician to replace the obsolete 3-terminal outlet.

AC Power

This equipment is Class I equipment, it must be grounded.

• If this equipment plugs into an outlet, the outlet must be near this equipment, and must be

easily accessible.

• Connect this equipment only to the power sources that are identified on the equipment-

rating label normally located close to the power inlet connector(s).

• If this equipment has two power sources be sure to disconnect all power sources before

working on this equipment.

• If this equipment does not have a main power switch, the power cord connector serves as

the disconnect device.

• Always pull on the plug or the connector to disconnect a cable. Never pull on the cable

itself.

• Unplug this equipment when unused for long periods of time.

Circuit Overload

Know the effects of circuit overloading before connecting this equipment to the power supply.

CAUTION:

Consider the connection of this equipment to the supply circuit and the effect that overloading of circuits

might have on overcurrent protection and supply wiring. Refer to the information on the equipment-rating

label when addressing this concern.