Installation Manual

Sensus Installation Manual

150-00006 Rev 5

4.3 Attaching Sensus Cable Fingers and Rack-Mounting the Sensus

Chassis

The Sensus chassis is rack mount capable and ships with rack 19” mount ears, with 21” and

23” adapters as optional accessories. These shall not be assembled on the chassis, but shall ship as

part of chassis order.

Rack mount ears are attached to the sides of the chassis using the included screws. Screw

length is not to exceed ¼ inch to avoid damage.

The Sensus cable fingers (optional) are used to maintain the proper bend tension to prevent

damage to cabling. These fingers secure to the rack mount ears as well as to the rack itself, and must

be installed when the chassis is mounted to the rack.

1. Line up the attached chassis mounting ears with the desired holes on the rack

2. Overlay cable support fingers onto the ears so that screw holes on the fingers, ears, and

rack are aligned

3. Secure with standard rack screws (not supplied)

4.4 Sensus Management Module Interfaces

4.4.1 Test SFP Cage, Console Port, USB and NFC Reader

Located on the front of the Sensus Management Module are the Test SFP cage, console port,

USB port, and NFC reader.

Figure 4-4 Sensus Management Module Front Ports