Specification

FiberCorr laminated panels
is a Trademark of Nudo Products, Inc.
Form 3005FC Rev. 01 8/13
1.800.826.4132 Phone
1.217.528.5636
1.217.528.8722 Fax
[e-mail]
www.nudo.com
NUDO!FiberCorr™!
Technical Data
3005FC
_____________________________________________________________ Rev. 01 8/13
NUDO FiberCorr™
Fiberglass Reinforced(FRP)
Laminated on Corrugated Plastic Core
Wall & Ceiling Panels
Nudo Products laminates FiberLite FRP to fluted polypropylene as a substrate [FiberCorr™] for use in
carwashes, food processing and agricultural building applications. All installations of these panels should be
approved by the local building code official prior to placing order for panels.
The FiberCorr laminated panels, with an embossed or smooth finish is designed for interior wall or ceiling
applications where durable panels are needed. FiberCorr is a durable wall and ceiling panel that is resistant
to mold, mildew and corrosion. FiberCorr finishes have been tested for flame spread and smoke
development per ASTM E-84 (see appropriate technical data). Nudo Products, Inc. makes no
representation or warranty as to the composite panel capability for any specific application, overall physical
properties, fire resistance, or burning characteristics when laminating FiberCorr to any substrate. Physical
properties and fire resistance technical data on the various substrates are available from the specific
substrate manufacturers. All installations of these panels should be approved by the local building code
official prior to placing order for panels.
LIMITATIONS OF PRODUCT:
FiberCorr laminated panels are designed as an indoor wall and ceiling panel. It should never be exposed to
extremely high or extremely low moisture conditions. Color distortion may also occur when panels are
exposed to excessive heat source that exceeds 130F (54C), such as ovens, deep fryers, stoves, etc. Panels
should be inspected on-site prior to installation. If any portion of the panels is not deemed acceptable, notify
Nudo Product immediately. Upon verification of unacceptable panels, Nudo Product will replace that portion
of the material, but will not take responsibility for the labor, other handling or installation expenses.
PRECONDITIONING:
Prior to installing FiberCorr laminated panel, remove the packaging materials and allow the panels to
acclimate to room temperature and humidity for at least 48 hours. Ideally, the room temperature and
humidity during acclimation and installation should be the same as the final operation conditions.
LAMINATED PANEL QUALITY, FABRICATION AND HANDLING
• FiberCorr laminated panels shall not delaminate from the substrate, when edges are securely fastened
to an adequate structural system, and when joints and edges are protected with a permanently flexible
silicone type caulking compound and suitable vinyl or aluminum division bars.
• FiberCorr laminated panels shall have good contact and uniform appearance over the entire surface of
the substrate.
• Alignment and adhesive squeeze-out between FiberCorr laminate and substrate will be to ± 1/16”
(1.5mm) on any edge.
• Panel weight will vary as a function of substrate thickness, density, and moisture content.
• FRP dimensional tolerances will be:
Width: +0” – 1/8” (4mm)
Length: ± 1/8” (4mm)
Squareness: 1/8” (4mm) in 48” (1.2m).
The color of the FiberCorr laminated panels shall be uniform as specified [Table 1].