Instructions / Assembly

23
Using a 5/32-in. bit, predrill two holes
through the bracket completely to dimple the
aluminum channel in two places. Remove
the bracket and drill completely through the
aluminum.
15
Place and hold the upper bottom rail stair bracket
on the outside of the U-channel, centering the
bracket and allowing approximately 1/32-in.
clearance from the edge.
14
Using a 5/32-in. bit, predrill two holes
through the bracket completely to dimple the
aluminum channel in two places. Remove
the bracket and drill completely through the
aluminum.
Align the #10 x 5/8-in. screws with the holes
on the underside of the aluminum U-channel,
and secure by driving them through the
aluminum channel and into the bracket. Do
not over tighten.
Note: The screw tips will be slightly exposed.
Handle with care.
Align the #10 x 5/8-in. screws with the holes
on the underside of the aluminum U-channel,
and secure by driving them through the
aluminum channel and into the bracket. Do
not over tighten.
Note: The screw tips will be slightly exposed.
Ensure that the protruding screw tips do not
block access to the bracket-to-post holes.
Handle with care.
18
16
19
Place and hold the lower bottom rail stair
bracket on the outside of the U-channel,
centering the bracket and allowing
approximately 1/32-in. clearance from the
edge.
17
The most recent installation instructions can be found on our website.
Please visit https://www.fiberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
Symmetry Railing Installation Instructions - Stair Aluminum Balusters