Installation Guide
2
Table of Contents
Table of Contents ...................................2
Safety Information ..................................2
Warranty ..........................................2
Pre-Installation .....................................3
Wood Surface Installation ............................5
Concrete Surface Installation ..........................7
Safety Information
Read and understand this entire manual before you begin the
installation of your surface mount.
WARNING: Use extreme caution when using power tools.
NOTE: The surface mount bracket is designed to be securely
mounted to a deck structure that meets all applicable codes.
The illustrations used in this guideline may not be appropriate
in all jurisdictions where the product is sold. To ensure proper
fastening, it is recommended that the concrete be a minimum of
4 inches thick underneath the mount unless otherwise specied
by local building codes.
For wood applications, it is recommended that the wood
structure be a minimum of 4 inches thick underneath the
decking and mount unless otherwise specied by local building
codes.
IMPORTANT: Please consult local zoning laws in regards
to load requirements and bottom space requirements for
rails. All supporting structures must be in accordance with
applicable building codes. Neighborhood associations and/
or historic districts may regulate size, type, placement
and ability of railing. Apply for permits if required by local
authorities and codes. Ensure compliance prior to installation.
Local building code requirements will always supersede
any and all suggested procedures and measurements in the
following installation. The following installation instructions
are intended as a general guideline based on common
building practices used in railing installation.
Warranty
20 YEAR PERFORMANCE LIMITED WARRANTY
WHAT IS COVERED
This railing product is covered under a Limited Residential Warranty to protect against checking, splitting, decay, rot and splintering.
WHAT IS NOT COVERED
In no event will the manufacturer be liable for any direct, indirect, incidental, special, consequential, punitive, exemplary, statutory, special,
or other, damages based upon the manufacturer products or manufacturer fasteners or resulting, directly or indirectly, from any defect in
the manufacturer products or fasteners, including but not limited to damage to, diminution in value of and/or loss of use or enjoyment of,
any property or part thereof, whether based on contract, tort, strict liability, statute, regulation or otherwise, even if the manufacturer is
expressly advised about the possibility of such damages. Some states do not allow the exclusion or limitation of incidental or consequential
damages in certain circumstances, so the above limitation may not apply to you.