Installation Guide

8
Concrete Surface Installation (continued)
4
Securing the post
□ Use a bubble level to check for plumb and level of the post.
If adjustment is required, place the leveling wedge (I) under
the post on any side where the post is leaning.
□ Tighten down the four concrete bolts until the head of the
concrete bolt is rmly seated with the post base. Do not
overtighten the bolts. If using a power impact wrench, the
maximum torque setting is 115 ft.-lbs.
A
I
B
5
Adding a post sleeve
□ Slide one plastic rail stabilizer (H) onto the post mount (A). The
slotted opening can be positioned in any direction.
□ Determine the height of the bottom rail. The bottom rail
mounting screws will screw into the rail stabilizer (H).
□ Secure the rail stabilizer (H) to the post mount (A) using one
#10 x 1 in. Phillips pan head rail stabilizer screw (G) through
the slotted area of the rail stabilizer (H).
□ Repeat for the top rail stabilizer (H). The top rail mounting
screws will screw into the the top rail stabilizer (H).
A
G
G
H
H
6
Adding a post sleeve
□ Slide the post sleeve (1) (not included) over the post mount
(A) until it contacts the base of the post mount (A).
NOTE: If using a post sleeve moulding (2), slide the post
sleeve (1) down into the post sleeve moulding (2) prior to
securing any railings.
A
1
2