Decking 2017 Installation Instructions Updated 12/16 for: Horizon, Symmetry, Paramount, Protect Advantage, Good Life, Relax, and Sanctuary Manufactured by fiberondecking.com 800.573.
Decking installation instructions Getting started Follow local approved building codes. Careful planning of the finished deck layout will result in better looking finished projects. Failure to follow installation guidelines could void warranty. 1 Perpendicular decking boards Joists Diagonal decking boards Joists Deck Boards Deck Boards • Before starting, material should be stored on a flat surface, supported every 24 in. (61 cm) and covered if original packaging is removed.
Decking installation instructions 2 4 Blocking End gapping Side-to-side spacing Stringers or Joists WALL LEDGER JOISTS/BLOCKING When installing blocking for more intricate decking patterns, remember that solid blocking (blocking laid on the flat) will inhibit water flow and result in buildup of organic materials over time, which will make cleaning more difficult. When blocking is required, install ladder style for best results.
Surface fastening and fascia instructions 5 6 Do not toe-nail Proper installation 1-1/2 in. (4 cm) from board end (.5 in. for Relax Decking) Dec 90-Degrees kB oar d# 1 Deck Board Deck Board Deck Dec kB Deck Deck Joist Joist oar d# Deck Board Board Joist/ Blocking Joist/ Blocking 2 Always drive in surface fasteners at a 90˚ angle to the decking surface with two fasteners at every joist location. Do not toe-nail screws into the joist.
Cortex hidden face-fastening instructions - square edge surface fastening system The Fiberon Cortex® hidden face fastening system is the fastest, easiest way to hide deck screw heads on stairs or perimeter boards. It is also the ideal fastener to use when replacing a deck board. The Cortex plugs are available in a variety of colors to match Fiberon deck boards (not avalable for Good Life or Relax Decking. Note: The use of non-Cortex screw or non-Cortex plug will nullify the warranty.
Hidden fastener instructions - grooved edge fastening systems Installing Paramount PVC decking All approved face fasteners and hidden fastener systems are listed on the fiberondecking.com website, including specific instructions for Paramount PVC grooved deck boards. These fasteners are designed to accommodate normal dimensional changes without material fracture or change in holding capability.
Hidden fastener instructions - grooved edge fastening systems How to finish the installation with end clips on the rim joist interior 3 Note: Prior to positioning the last deck board, place the end clips on the inside of the rim joist, securing them with a single screw inserted perpendicular through each clip into the joist. 1 Phantom GT 2 Secure fasteners by driving the screw fully into joist.
Post sleeve installation Fiberon composite railing systems are designed to work with a number of different decking materials and surfaces. Before initiating any project, be sure you fully understand all local building codes. Local building code requirements will always supersede any and all suggested procedures and measurements in the following guidelines. Fiberon Deck Designer For Rail posts may be installed by using the structural posts that support the joists, or by using a surface mount bracket.
Post sleeve installation to structural posts Guardrails can be secured to structural 4 in. X 4 in. posts, or to 4 in. X 4 in. posts secured to the support framing in a code-approved manner. Always check to ensure posts are plumb and true. Check maximum and minimum distance requirements for the railing that is being installed to ensure a snug fit and proper baluster spacing. 2 1 Determine the desired height of the post sleeve. Typically, the height is no less than 2 in.
Design Grid fiberondecking.