Installation Guide
4
The most recent installation instructions can be found on our website. Please visit berondecking.com or call Consumer and Technical Support at 800-573-8841.
Decking installation instructions
Side-to-side spacing
End gapping
JOISTS/BLOCKING
LEDGER
WALL
Stringers or Joists
Blocking
4
2
3
Same direction
Wood grain orientation during installation
Alternating direction
Achieve different looks by laying the decking in the same or
alternating directions. There are several different wood grain
patterns to provide a less repetitive and natural wood appearance.
The graining pattern repeats approximately every 44 in. (1.12 m)
along the board length. During the planning phase of any deck
project, arrange decking before installation to achieve the desired
pattern and color effect. This is also important if different lengths/
bundles of material are used as different wood grain patterns and
color tones may need to be mixed to achieve the desired look.
All decking materials, whether wood, composite or metal, undergo
some degree of linear expansion with the changes of weather and
the season. For best spacing results, keep boards out of direct sun
during storage and cutting processes, and throughout installation
if possible. Never cut and install boards in direct sunlight. To
compensate for the effects of contraction and expansion, use short
boards where possible with splitter/divider boards between each
continuous run of boards.
Adequate board spacing of a minimum 3/16 in. between board sides
will provide proper drainage and ventillation while assisting with the
removal of small organic debris. Allow a minimum of 1/4 in. spacing
between boards and any permanent structure. Spacing requirements
must be met for full Fiberon warranty coverage.
Note: Special consideration should be taken when working with
dark colors as they will experience larger temperature swings during
normal use. To help control end-to-end spacing, dark color decking
should be kept at ambient temperature and shaded from direct sun
prior to cutting and immediate securing. Using lighter colored boards
in the eld of the deck with darker colored boards as design accents
creates less visible gapping.
End-to-end spacing by temperature
Brand
35˚ &
Under
36˚ - 69˚ 70˚ - 89˚ 90˚ - 109˚ 110˚ & Up
Paramount 1/16 in. 1/32 in. 1/32 in. 0 in. 0 in.
Horizon 1/4 in. 3/16 in. 1/8 in. 1/16 in. 1/32 in.
Sanctuary 1/4 in. 3/16 in. 1/8 in. 1/16 in. 1/32 in.
ProTect
Advantage
1/4 in. 3/16 in. 1/8 in. 1/16 in. 1/32 in.
Good Life 1/4 in. 3/16 in. 1/8 in. 1/16 in. 1/32 in.
Docking 1/4 in. 3/16 in. 1/8 in. 1/16 in. 1/32 in.
Note: For locations with extreme temperature swings, double joists
and surface fastening may be required to minimize shifting of material.
When installing blocking for more intricate decking patterns,
remember that solid blocking (blocking laid on the at) will inhibit
water ow and result in buildup of organic materials over time, which
will make cleaning more difcult. For best results when blocking is
required, install ladder style.