Installation Guide
Note: Rail lengths will vary slightly due to manufacturing processes. Make sure rails are cut
properly to correct length, and with hole pattern centered between posts before securing.
Fiberon
®
Horizon
®
Railing 6 and 8 ft. Installation Instructions
Required Tools and Supplies:
Top Rail Prole
Bottom Rail Prole
• Power Drill
• 1/8 in. Drill Bit
• #2 Square Head Bit
• Protective Eye Wear
• Tape Measure
• Level
• Screw Driver, Phillips #2
• Speed Square
• Miter Saw
• Pencil
• Adjustable Square
Post Sleeve
Cap
Top Rail Bracket
Top Rail
Bottom Rail
Square
Balusters
Bottom Rail Bracket
YES
2-1/8 in. minimum from rail end to baluster
NO
Post Sleeve
Post Sleeve
Base Moulding
Prior to installing railing: Please consult local zoning laws in regard to load requirements and bottom space requirements for rails. All
supporting structures must be in accordance with applicable building codes. Neighborhood associations and/or historic districts may regulate
size, placement and type of railing. Apply for permits if required by local authorities and codes. Ensure compliance prior to installation. Local
building code requirements will always supersede any and all suggested procedures and measurements in the following installation. The
following installation instructions are intended as a general guideline based on common building practices used in railing installation.
When top and bottom rail length is greater than the distance between posts, trim both top and bottom rail ends to maintain uniform baluster
spacing. Slide post sleeve base moulding over each post prior to installing bottom rails and press securely into place.
Rail Installation: Trim both ends of rail to maintain uniform baluster spacing. It is critical to ensure the trim mark does not create an open
baluster insert hole at the end of the rail where the bracket is attached. Adjust trim lines to maintain uniform baluster spacing.
Adjustable Crush Block
Railing component list for each section:
Maximum length between post sleeves is 72 inches for a 6 ft. rail or 96 in. for an 8 ft. rail.
1
The most recent installation instructions can be found on our website. Please visit berondecking.com or call Consumer and Technical Support at 800-573-8841.