Installation Guide

13 FIBERONDECKING.COM
Please contact 1-800-230-7547 for further assistance.
Angle Bracket Installation
NOTE: The angle bracket is available as a Special Order purchase, or from homedepot.com.
1
Determining the angle of installation
NOTE: Not for stair applications.
NOTE: The minimum distance from post corner to the rst
baluster hole is 1.5 in.
□ Determine the angle of your installation using the supplied
template and cut the template out along the appropriate
marked lines. (You may want to photocopy the template as
a backup prior to cutting).
□ Position the template on the non-routed, underside surface
of the bottom rail. Mark the proper cutting angle. Template
will be reversed from the top rail.
□ Ensure baluster holes are equidistant from the end of rail to
ensure proper vertical alignment of balusters.
45
40
35
30
25
20
20
25
30
35
40
45
2
Making the angle cuts
□ Make the angle cuts in the top and bottom rails.
45
40
35
30
25
20
45
3
Installing the angle brackets
□ Align the angle bracket (MM) with the cut in each rail. Inset
the bracket 1/16 in. from the rail’s end.
□ Mark the three screw hole locations on both ends of each
rail and pre-drill the holes using a 5/32 in. bit.
□ Secure the brackets with the 1 in. screws (KK). DO NOT
OVERTIGHTEN THE SCREWS.
KK
MM
4
Installing the bottom rail
□ Secure the bottom rail to the posts using the
2 in. screws (LL).
□ Follow Steps 5 through 9 in the line rail instructions.
LL