Installation Guide

Symmetry Railing Installation Instructions - Angled Line
7
Center the hole pattern in the bottom rail
between the posts. Measure and transfer
the length and cutting angles. Place the
U-channel inside the bottom rail and cut
together. When transferring length and
cutting angles to the H-bar, remember to
subtract 7/32-in. from each end to allow for
top brackets.
3
Note: Make sure that the bottom rail is
positioned correctly prior to cutting the
bottom rail angle for installation. The bottom
rail has an aligning feature on the top,
which should be on the yard side of the rail,
opposite to the deck side.
Aligning feature
Yard Side Deck Side
2
Cover 4x4 posts or Fiberon surface mount
bracket with post sleeve and verify spacing.
Posts should be plumb in both directions.
Place post sleeve base moulding over post
sleeve and slide it down to the deck surface.
Note: Make sure posts are plumb and level
prior to installing the railing.
1
For angled line installation, the line brackets
will need to be installed with the angled
edge on the deck side of the railing.
Note: This is opposite of what is indicated
on the line brackets for basic line railing
installation.
4
Deck Side Yard Side
The most recent installation instructions can be found on our website.
Please visit https://www.fiberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.