Installation Guide

Secure using the supplied #10 x 5/8-in. self-

drilling screws.

Approximate center on a rail

section with even balusters

Position the crush block and holder into the

bottom rail, and locate the two screw holes.

Remove the holder and predrill using a 1/8-in.

drill bit. Reposition the crush block and holder,

and secure with the supplied #8 x 1-in. screws.

Do not over tighten.

Secure the bottom stair brackets to the post

using the supplied pan head screws at the

desired height. Do not over tighten.

Note: For best results predrilling bracket holes

on post with a 1/8-in. - 5/32-in. bit is strongly

recommended to ensure accurate screw

placement and full insertion, particularly as the

stair angle increases.

Carefully position the pre-assembled railing

inﬁll between the posts, then slowly lower over

the bottom brackets until fully seated.

Center the H-bar on the post and check rail

for plumb.

Approximate 1/3 and 2/3

with even baluster count

Starting at the top, secure the H-bar to the

posts at both ends using the supplied #10 x

2-1/2-in. self-drilling pan head screws. Do not

over tighten.

For 6-ft. rails sections, position the crush

block and holder inside the bottom rail at the

approximate center point.

For 8-ft. rail sections, position the two crush

blocks and holders inside the bottom rail at

the approximate 1/3 and 2/3 points.

Cut the crush block to the required length.

Secure crush block to the crush block

holder using a supplied #8 x 1-in. screw.

Note: the screw will be off-center in the

crush block.

The most recent installation instructions can be found on our website.

Please visit https://www.ﬁberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.

Symmetry

Railing Installation Instructions - Stair Aluminum Balusters