Installation Guide
8
7
To cut the H-bar, rst place the H-bar on
its side with the holes nearest to the cut
bottom rail. The bottom rail should be top
side up. Align the hole pattern with the cut
bottom rail.
Symmetry Railing Installation Instructions - 6-ft. and 8-ft. Stair
8
9
10
Transfer the length of the cut bottom rail to
the H-bar.
Scribe the stair angle to the side of the
H-bar at both ends.
The total length of the H-bar will be 7/16-in.
shorter than the cut bottom rail.
Scribe a second line 7/32-in. inside the rst
rst at both ends.
Note: This allows for the thickness of the
upper bracket.
11
Position the top brackets into the H-bar,
ensuring that they are inserted completely.
Secure the top brackets to the H-bar using
(two) 5/8-in. self-drilling pan head screws. Do
not over tighten.
12
The most recent installation instructions can be found on our website.
Please visit https://www.berondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
Square Composite Balusters: Remove the
baluster guide from the rail box. Place on a
at surface and insert the balusters into the
precut slots.
Round Metal Balusters: Place cut bottom rail
on a at level surface. Align the cut-end of
the round metal baluster with the top surface
of the bottom rail.
13
Square Composite Balusters: Align the end
baluster with the predrilled hole in the bottom
rail. Secure the balusters using the supplied
#10 x 1-1/2-in. screws.
Hold each square composite baluster securely
against the aligning feature and drive screws
parallel with the balusters, not perpendicular
to the bottom rail. Do not over tighten.
Round Metal Balusters: Insert the screw into
the center “X” of the end baluster. It may be
necessary to slightly over-drill the factory
drilled holes by rocking the moving bit parallel
with the direction of the rail. Do not over
tighten.
Continue working from one end until all the
balusters are secured into the bottom rail.
14