Installation Guide

10
Carefully position the pre-assembled railing in-
ll between the posts, then slowly lower over
the bottom brackets until fully seated.
21
Center the H-bar on the post and check rail
for plumb.
22
Starting at the top, secure the H-bar to
the posts at both ends using the supplied
#10 x 2-½-in. self-drilling pan head screws.
Do not overtighten.
23
HavenView
™
CountrySide Installation Instructions - 6-ft. and 8-ft. Stair
Position the top rail over the inll assembly,
and carefully lower into place.
24
Using supplied 1-½-in. screws, secure the top
rail starting as close to the post as possible.
Space the remaining screws evenly.
25
Complete the assembly by gluing the post
caps in place with a quality exterior-grade
adhesive.
26
The most recent installation instructions can be found on our website.
Please visit https://www.berondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
Position the crush block and holder into the
bottom rail, and locate the two screw holes.
Remove the holder and pre-drill using a
1/8-in. drill bit. Reposition the crush block and
holder, and secure with the supplied #8 x 1-in.
screws. Do not overtighten.
20