User's Manual

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved
H380-GL Hardware User Manual Page
9
of
47
This device is designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to
the antenna shall not be less than 20cm (8 inches) during normal operation.
R&TTE Regulation:
In all cases assessment of the final product must be mass against the Essential requirements of the
R&TTE Directive Articles 3.1(a) and (b), safety and EMC respectively, as well as any relevant Article 3.3
requirements.
Human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
The maximum antenna gain for frequency 900 is 3dBi; for frequency 1800 is 5 dBi.
EU Regulatory Conformance
Hereby, FIBOCOM Wireless Inc. declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
IC Canada Statement：
This device complies with Part 15 of the FCC Rules and with RSS-247 of Industry Canada. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible
d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.