User's Manual
Table Of Contents
- This device is intended only for OEM integrators under the following conditions:
- 1 Foreword
- 1.1 Introduction
- 1.2 Reference Standard
- 1.3 Related Documents
- 2 Overview
- 2.1 Introduction
- 2.2 Specification
- 2.3 CA combinations
- 2.4 Application Framework
- 2.5 Hardware Block Diagram
- 2.6 Antenna Configuration
- 3 Application Interface
- 3.1 M.2 Interface
- 3.1.1 Pin Map
- Note:
- 3.1.2 Pin Definition
- 3.2 Power Supply
- 3.2.1 Power Supply
- 3.2.2 Logic level
- 3.2.3 Power Consumption
- 3.3 Control Signal
- 3.3.1 Module Start-Up
- 3.3.1.1 Start-up Circuit
- 3.3.1.2 Start-up Timing Sequence
- 3.3.2 Module Shutdown
- 3.3.3 Module Reset
- Note:
- 3.3.4 PCIe Reset
- 3.4 PCIe & USB
- 3.4.1 PCIe Interface
- 3.4.1.1 PCIe Interface Definition
- 3.4.1.2 PCIe Interface Application
- 3.4.2 USB Interface
- 3.4.2.1 USB Interface Definition
- 3.4.2.2 USB2.0 Interface Application
- 3.5 USIM Interface
- 3.5.1 USIM1 Pins
- 3.5.2 USIM2 Pins
- 3.5.3 USIM Interface Circuit
- 3.5.3.1 N.C. SIM Card Slot
- 3.5.3.2 N.O. SIM Card Slot
- 3.5.4 USIM Hot-Plugging
- 3.5.5 USIM Design
- 3.6 Status Indicator
- 3.6.1 LED#1 Signal
- Note:
- 3.7 Interrupt Control
- 3.7.1 W_DISABLE1#
- 3.7.2 BODYSAR
- 3.8 ANT Tunable Interface
- 3.9 Configuration Interface
- 3.10 Other Interfaces
- 4 Radio Frequency
- 4.1 RF Interface
- 4.1.1 RF Interface Functionality
- 4.1.2 RF Connector Characteristic
- 4.1.3 RF Connector Dimension
- 4.2 Operating Band
- 4.3 Transmitting Power
- 4.4 Receiver Sensitivity
- 4.4.1 Dual Antenna Receiver Sensitivity
- Note:
- 4.4.2 Four Antenna Receiver Sensitivity
- Note:
- 4.5 GNSS
- Note:
- 4.6 Antenna Design
- 5 Structure Specification
- 5.1 Product Appearance
- 5.2 Dimension of Structure
- 5.3 M.2 Interface Model
- 5.4 M.2 Connector
- 5.5 Storage
- 5.5.1 Storage Life
- 5.6 Packing
- 5.6.1 Tray Package
- 5.6.2 Tray size
Reproduction forbidden
without
L860-GL Hardware User Manual
Operating Band Description
Band 42 3500MHZ
Band 46 5200MHZ
GPS L1
-
GLONASS L1
-
BeiDou
-
4.3 Transmitting
Power
The transmitting power for each band of the L860 module as shown in the following table:
Mode Band
3GPP Requirement(dBm)
WCDMA
Band 1 24+1.7/
-
Band 2 24+1.7/
-
Band 4 24+1.7/
-
Band 5 24+1.7/
-
Band 8 24+1.7/
-
LTE FDD
Band 1
23±2.7
Band 2
23±2.7
Band 3
23±2.7
Band 4
23±2.7
Band 5
23±2.7
Band 7
23±2.7
Band 8
23±2.7
Band 12
23±2.7
Band 13
23±2.7
Band 14
23±2.7
Band 17
23±2.7
Band 18
23±2.7
Band 19
23±2.7
Band 20
23±2.7
without
Fibocom Wireless Inc. written authorization - All
Rights
Mode Tx (MHz)
LTE TDD 3400
LTE TDD N/A
-
/
-
/
-
/
Power
The transmitting power for each band of the L860 module as shown in the following table:
3GPP Requirement(dBm)
Tx Power(dBm) Note
-
3.7 23.5±1
-
-
3.7
23.5±1
-
-
3.7
23.5±1
-
-
3.7 23.5±1
-
-
3.7
23.5±1
-
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth,
23±1
10MHz Bandwidth, 1 RB
23+2/-1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
23±1
10MHz Bandwidth, 1 RB
Rights
Reserved.
Page 42 of 53
Rx (MHz)
3400
– 3600
5150 – 5925
1575.42±1.023
1602.5625±4
1561.098±2.046
The transmitting power for each band of the L860 module as shown in the following table:
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth,
1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz
Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
10MHz Bandwidth, 1 RB
FIBOCOM