User's Manual

FIBOCOM B830-GL Hardware User Manual_HP Customization Version Page 8 of 29

operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

(1) Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate this equipment.

(2) This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Federal Communication Commission Radiation Exposure Statement

This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE

C95.1-1999 and had been tested in accordance with the measurement methods and procedures

specified in OET Bulletin 65 Supplement C.

This device is intended only for OEM integrators under the following conditions:

1) The Max allowed antenna gain is 2 dBi for external monopole antenna and PIFA antenna

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM

integrator is still responsible for testing their end-product for any additional compliance requirements

required with this module installed。

End Product Labeling

The final end product must be labeled in a visible area with the following: “Contains FCC

ID:ZMOB830GL”.The grantee's FCC ID can be used only when all FCC compliance