Hardware Guide
Table Of Contents
- Fibocom_FM101-CG_Hardware_Guide_V1.0.pdf
- FM101-CG-20: Hardware Guide
- Contents
- Change History
- 1. Foreword
- 2. Product Overview
- 3. Pin Definition
- 4. Electrical Characteristics
- 5. Functional Interface
- 6. Radio Frequency
- 6.1. RF Interface
- 6.2. Operating Bands
- 6.3. Transmitting Power
- 6.4. Receiving Sensitivity
- 6.5. GNSS Receiving Performance
- 6.6. Antenna Design
- 6.7. PCB Routing Design
- 6.8. Main Antenna Design
- 6.9. Diversity and MIMO Antenna Design
- 6.10. GNSS Antenna Design
- 6.11. Other Interfaces
- 7. Thermal Design
- 8. Electrostatic Protection
- 9. Structural Specifications
- Appendix A: Acronyms and Abbreviations
- Module FCC & ISED警语 for Fibocom
Pin
Number
Pin Name I/O
Reset
Status
Pin Description Type
26
W_DISABLE2
#
DI PU
GNSS positioning is disabled,
active low, reserved
CMOS
3.3V/1.8V
27 GND - - - - Ground
Power
supply
28 I2S_WA DO PD
I
2
S byte selection, left and right
channels, reserved
CMOS
1.8V
29
USB_SS_TX_
M
DO *
Ultra high speed USB data
transmitting negative
*
30 UIM1_RESET DO L SIM card 1 reset
CMOS
3V/1.8V
31 USB_SS_TX_P AO *
Ultra high speed USB data
transmitting positive
*
32 UIM1_CLK DO L SIM card 1 clock
CMOS
3V/1.8V
33 GND - - - - Ground
Power
supply
34 UIM1_DATA DIO L SIM card 1 data
CMOS
3V/1.8V
35
USB_SS_RX_
M
AI *
Ultra high speed USB data
receiving negative
*
36 UIM1_PWR PO *
SIM card 1 power supply,
3V/1.8V
CMOS
3V/1.8V
37 USB_SS_RX_P AI *
Ultra high speed USB data
receiving positive
*
38 WAKEUP_IN DI *
Peripheral wake-up module
control signal
CMOS
1.8V
3. Pin Definition
Copyright © Fibocom Wireless Inc. 16