Hardware Guide
Table Of Contents
- Fibocom_FM101-CG_Hardware_Guide_V1.0.pdf
- FM101-CG-20: Hardware Guide
- Contents
- Change History
- 1. Foreword
- 2. Product Overview
- 3. Pin Definition
- 4. Electrical Characteristics
- 5. Functional Interface
- 6. Radio Frequency
- 6.1. RF Interface
- 6.2. Operating Bands
- 6.3. Transmitting Power
- 6.4. Receiving Sensitivity
- 6.5. GNSS Receiving Performance
- 6.6. Antenna Design
- 6.7. PCB Routing Design
- 6.8. Main Antenna Design
- 6.9. Diversity and MIMO Antenna Design
- 6.10. GNSS Antenna Design
- 6.11. Other Interfaces
- 7. Thermal Design
- 8. Electrostatic Protection
- 9. Structural Specifications
- Appendix A: Acronyms and Abbreviations
- Module FCC & ISED警语 for Fibocom
Pin
Number
Pin Name I/O
Reset
Status
Pin Description Type
39 GND - - - - Ground
Power
supply
40
SIM2_DETEC
T
DI *
SIM card 2 detection, and
external pull-up and pull-down
are required. A card is available
at high level by default,
SPI_MISO (Reserved)
CMOS
1.8V
41 PETn0 DO * PCIe data transmitting negative *
42 UIM2_DATA DIO L
SIM card 2 data, SPI_MOSI
(Reserved)
CMOS
3V/1.8V
43 PETp0 DO * PCIe data transmitting positive *
44 UIM2_CLK DO L
SIM card 2 clock, SPI_CLK
(Reserved)
CMOS
3V/1.8V
45 GND - - - - Ground
Power
supply
46 UIM2_RESET DO L
SIM card 2 reset,
SPI_CS(Reserved)
CMOS
3V/1.8V
47 PERn0 DI * PCIe data receiving negative *
48 UIM2_PWR PO * SIM card 2 power supply
CMOS
3V/1.8V
49 PERp0 DI * PCIe data receiving positive *
50 PERST# DI PD
Module PCIe interface reset.
Active low, and an external pull-
up resistor is required
CMOS
3.3V/1.8V
51 GND - - - - Ground
Power
supply
3. Pin Definition
Copyright © Fibocom Wireless Inc. 17