Hardware Guide
Table Of Contents
- Fibocom_FM101-CG_Hardware_Guide_V1.0.pdf
- FM101-CG-20: Hardware Guide
- Contents
- Change History
- 1. Foreword
- 2. Product Overview
- 3. Pin Definition
- 4. Electrical Characteristics
- 5. Functional Interface
- 6. Radio Frequency
- 6.1. RF Interface
- 6.2. Operating Bands
- 6.3. Transmitting Power
- 6.4. Receiving Sensitivity
- 6.5. GNSS Receiving Performance
- 6.6. Antenna Design
- 6.7. PCB Routing Design
- 6.8. Main Antenna Design
- 6.9. Diversity and MIMO Antenna Design
- 6.10. GNSS Antenna Design
- 6.11. Other Interfaces
- 7. Thermal Design
- 8. Electrostatic Protection
- 9. Structural Specifications
- Appendix A: Acronyms and Abbreviations
- Module FCC & ISED警语 for Fibocom
USIM1_VDD
USIM1_D
ATA
USIM1_CLK
USIM1_RST
USIM1_DET
USIM2_VDD
USIM2_D
ATA
USIM2_CLK
USIM2_RST
USIM2_DET
VDD
D
AT
CLK
RST
VPP
CD
22R
0.1uF
Module
Car
d connector
22R
1K
47K
47K
22R
20K
33pF
NC
NC
NC
VDD
D
AT
CLK
RST
VPP
CD
0.1uF
33pF
NC
NC
NC
22R
22R
1K
22R
20K
Car
d connector
VDD-EXT-1V8
GND
GND
Figure 12. (U)SIM card slot with card detection signal
5.4.3. (U)SIM Card Hot Plug
The FM101-CG series module supports the (U)SIM card hot plug function. The module
detects the status of the USIM1_DET/USIM2_DET pin to determine whether a (U)SIM card
is inserted or removed.
USIM1_DET/USIM2_DET is active high by default (if the card is at high level, the card is
inserted; otherwise, the card is removed). The hot plug detection can be
enabled/disabled by the AT command as follows.
Table 19. (U)SIM card hot plug function configuration
AT Command Function Remark
AT+MSMPD=1
(U)SIM card hot plug detection is
enabled
Default setting
5. Functional Interface
Copyright © Fibocom Wireless Inc. 32