User's Manual
Table Of Contents
- Applicability Table
- Copyright
- Notice
- Trademark
- Version Record
- 1 Foreword
- 2 Overview
- 3 Application Interface
- 4 Radio Frequency
- 5 Thermal Design
- 6 Structure Specification
Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM FM150-NA User Manual Page 59 of 72
4.1.4 RF Connector Assembly
Mate RF connector parallel refer Figure 4-5, do not slant mate with strong force.
Figure 4-5 Mate RF connector
To avoid damage to the RF connector during extraction, it is recommended to use pulling JIG as Figure
4-6, and the pulling JIG must be lifted up vertically to PCB surface (see Figure 4-7 and 4-8).
Figure 4-6 Pulling JIG
Figure 4-7 Lift up pulling JIG