User's Manual

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM FM150-NA User Manual Page 34 of 75
Pin Pin Name I/O Reset Value Pin Description Type
70 VCC PI
-
Power input Power Supply
71 GND
- -
GND Power Supply
72 VCC PI
-
Power input Power Supply
73 NC
- -
-
74 VCC PI
-
Power input Power Supply
75 CONFIG_2 O
NC
NC, FM150 M.2 module is configured
as the WWAN – PCIe, USB_SS
interface type.
-
Reset Value: The initial status after module reset, not the status when working.
H: High Voltage Level
L: Low Voltage Level
PD: Pull-Down
PU: Pull-Up
T: Tri s t a t e
OD: Open Drain
PI: Power Input
PO: Power Output
Notes:
1. The unused pins can be left floating.
2. All interfaces that support 3.3V voltage are based on the input voltage of + 3.3V power
supply. When the input voltage range of the power supply changes from 3.135V to 4.4V, the
corresponding interface voltage changes accordingly.
3.2 Power Supply
The power interface of FM150 module as shown in the following table:
Pin Pin Name I/O Pin Description
DC Parameter (V)
Minimum
Value
Typical
Value
Maximum
Value
2, 4, 70, 72, 74 VCC PI Power supply input 3.135 3.8 4.4
36 UIM1_PWR PO USIM power supply
-
1.8V/3V -
48 UIM2_PWR PO USIM power supply
-
1.8V/3V -