User's Manual

FIBOCOM N510-GL Hardware User Manual Page 15 of 56

permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2

Certification (labeling requirements) above). The OEM manual must provide clear instructions

explaining to the OEM the labeling requirements, options and OEM user manual instructions that are

required (see next paragraph).

For a host using a certified modular with a standard fixed label, if (1) the module’s FCC ID is not visible

when installed in the host, or (2) if the host is marketed so that end users do not have straightforward

commonly used methods for access to remove the module so that the FCC ID of the module is visible;

then an additional permanent label referring to the enclosed module:“Contains Transmitter Module FCC

ID: ZMON510GL” or “Contains FCC ID: ZMON510GL” must be used. The host OEM user

manual must also contain clear instructions on how end users can find and/or access the module and

the FCC ID.

The final host / module combination may also need to be evaluated against the FCC Part 15B criteria

for unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the

user that changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. In cases where the manual is provided only in

a form other than paper, such as on a computer disk or over the Internet, the information required by

this section may be included in the manual in that alternative form, provided the user can reasonably be

expected to have the capability to access information in that form.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the manufacturer could void the user’s authority to

operate the equipment.

To ensure compliance with all non-transmitter functions the host manufacturer is responsible for ensuring

compliance with the module(s) installed and fully operational. For example, if a host was previously

authorized as an unintentional radiator under the Supplier’s Declaration of Conformity procedure without

a transmitter certified module and a module is added, the host manufacturer is responsible for ensuring

that the after the module is installed and operational the host continues to be compliant with the Part 15B

unintentional radiator requirements.

Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install or

remove this RF module in the user’s manual of the end product which integrates this module. The end user

manual shall include all required regulatory information/warning as show in this manual.