User Guide

Installation and Upgrade
FIC A440 Series Service Manual 2-3
2.2.2 Installing the DVD-ROM or CD-ROM Driver (For DOS)
This section provides installation guide for the DVD-ROM or CD-ROM device driver under
MS-DOS and other operating systems.

For DOS installation, you must have a pre-installed MS-DOS v6.0 or higher
operating system on your hard disk with the “MSCDEX.EXE“ (Microsoft CD
Extension) driver file. For DOS, this is located under the DOS directory. For
Windows 95/98, this is located under the \WINDOWS\COMMAND subdirectory.
Installing the CD-ROM driver under DOS prompt
1. Boot up the system of your computer and insert the Teac CD-ROM driver diskette into
the floppy drive.
2. Change the directory of the DOS prompt to Drive A and run the CD-ROM installation
program by typing the command
A:\>INSTALL
.
3. The CD-ROM Setup program will appear and ask you for directory name where the
driver will be installed. Press <Enter> to install into the default directory.
4. With "Auto Select" selected, press <Enter> to continue with the installation.
5. With "Modify the file now" selected, press <Enter> to modify AUTOEXEC.BAT file.
6. With "Modify the file now" selected, press <Enter> once again to modify CONFIG.SYS
file.
7. Finally, press <Enter> to complete installation. Then, restart the computer after
installation is complete. Your computer will then detect the CD-ROM drive and will
display the designated drive letter. The CD-ROM drive should be assigned to Drive D. If
you have two disk partition, the CD-ROM drive will be assigned to Drive E.
Installing the DVD-ROM driver under DOS prompt
1. Boot up the system of your computer and insert the Toshiba DVD-ROM driver diskette
into the floppy drive.
2. Change the directory of the DOS prompt to Drive A and run the DVD-ROM installation
program by typing the command
A:\>INSTALL
.
3. The DVD-ROM Setup program will appear and ask you to press <Enter> to start
installation or press <ESC> key to exit installation program.
4. A connection diagram appears with a message shown "Confirm the connection
environment of the computer, Are you sure?" Press <Y> to confirm.
5. The installation program will ask you to specify the directory where you want to place the
DVD-ROM driver. Press <Enter> to install into the default directory.
6. Press <Enter> to continue with the next step.