User Guide

ManualsBrandsField Controls ManualsBoiler Venting80+ Gas Draft Induced Furnace Vent Kit

page 5

NOTE: Vent pipe joints should be secured with at least three sheet

metal screws. Use a PEK series extension kit or follow installation

method below for a double pipe system. When the outer pipe of

the SWG is extended over the inner pipe, use the double pipe

guidelines for determining clearances.

INSTALLATION USING TYPE B VENT PIPE

1. Using a hand crimper or a like device, crimp the inner pipe of

the SWG power venter approximately 1" long. (See Figure 4)

2. Attach the vent pipe over the crimped end of the SWG power

venter inner pipe.

3. Secure the vent pipe to the SWG power venter inner pipe with

at least three (3) #8 sheet metal screws. Pre-drilling the

holes through both pipes will allow easier fastening.

PEK-4HD EXTENSION KIT INSTALLATION

INSTRUCTIONS (Optional)

(Includes an air adjustment damper plate)

1. Remove the End pan from the SWG Venter.

(See Figure 5)

2. Using a pair of sheet metal cutters, cut the Damper Plate

Adjustment Bracket. (See Figure 6) Then remove the

Damper Plate and Adjustment Bracket.

3. Install the Extension by starting the inner pipe into the

attaching section rst, then lightly tap the end of the

inner and outer pipe into the attaching section until the

rib on the crimped end touches the attaching pipe. The

lock seam of the pipe should be on the top of the pipe.

NOTE: The Extension Kit can be added onto the SWG

Venter directly or by attaching equal lengths of pipe to the

inner and outer pipes, then the Extension Kit can be added

closer to the heating unit.

4. Make sure damper plate rotates freely, then fasten the

outer pipe with at least three (3) sheet metal screws.

INSTALLATION CLEARANCE WITH SINGLE WALL VENT PIPE

DOUBLE PIPE SYSTEM SINGLE PIPE VENTING SYSTEM

Allowable Inlet Temperature Clearance (A) Allowable Inlet Temperature Clearance (A)

400ºF Or Less

⁄2" Minimum 400ºF Or Less

⁄2" Minimum

400ºF To 550ºF 1" Minimum 400ºF To 550ºF 1" Minimum

400ºF To 550ºF

⁄2" Minimum

With Sheet Metal Liner

400ºF To 550ºF

⁄2" Minimum

With Sheet Metal Liner

Figure 4

Figure 6

Figure 5

Table 3