User Guide

ManualsBrandsField Controls ManualsOther46457800

SYSTEM CONTROL KIT

Model: CK-41P

READ THE INSTALLATION INSTRUCTIONS CAREFULLY & COMPLETELY BEFORE BEGINNING THE INSTALLATION!

Designed for use with the SWG Series Power Venter for controlling Natural

Gas or L.P. Gas Appliances equipped with a 24V electric damper. It is

designed for modular connection to the appliance controls via the damper

cable connection.

TEMS INCLUDED IN KIT

1) Control box with mounted pressure switch, post purge timer and

7” vent damper cable

2) Flexible conduit connector

1) ¼” tubing connectors

TEMS NOT INCLUDED IN KIT

• ¼” O.D. aluminum, copper or stainless steel tubing

• Junction box with connectors and additional circuit wiring, if

required

DO NOT DESTROY

THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT

WARNING: INSTALLER: IF THE APPLIANCE DOES NOT HAVE A BLOCKED VENT

SWITCH, A GSK-3P SPILLAGE SWITCH KIT, P/N 46458600, (NOT INCLUDED)

MUST BE INSTALLED (SEE DIAGRAM B).

Summary of content (8 pages)

PAGE 1
SYSTEM CONTROL KIT Model: CK-41P READ THE INSTALLATION INSTRUCTIONS CAREFULLY & COMPLETELY BEFORE BEGINNING THE INSTALLATION! Designed for use with the SWG Series Power Venter for controlling Natural Gas or L.P. Gas Appliances equipped with a 24V electric damper. It is designed for modular connection to the appliance controls via the damper cable connection.
PAGE 2
MOUNTING CONTROL BOX The control box must be mounted within 6’ of the vent damper, and within reach of the appliance’s existing damper cable. If the control box must be mounted out of reach of the power venter’s attached wiring, an additional installer supplied junction box and wiring (with approves wiring enclosure if necessary) will be required. (See Figure 1 & 2) 1. Install the flexible conduit connector onto the CK-41P control box and secure with fastening nut.
PAGE 3
WIRING CAUTION: Disconnect electrical power when wiring power venter Wire the venter motor and controls in accordance with the National Electrical Code, manufacturer's recommendations and/or applicable local codes. Units must be grounded. Check ground circuit to make certain that the unit has been properly grounded. The wiring should be protected by an overcurrent circuit device rated at 15 amperes. CAUTION must be taken to ensure that the wiring does not come into contact with any heat source.
PAGE 4
SYSTEM CONTROL CHECK OUT PROCEDURES 1. Adjust the thermostat and/or aquastat to call for heat and observe the power venting system for proper operation sequence. (Repeat if necessary) a. b. c. d. e. Aquastat calls for heat. After a short delay, the relay is energized, the venter motor starts and the vent damper begins opening. Pressure switch closes, the vent damper reaches the open position and the burner starts. Aquastat is satisfied, the burner stops and the vent damper begins closing.
PAGE 5
INTERNAL WIRING L1 TO 1 ON POST PURGE TIMER M TO 3 ON POST PURGE TIMER (OTHERS PER HARNESS COLORS) REPAIR AND REPLACEMENT PARTS LIST REPAIR AND REPLACEMENT PARTS LIST DESCRIPTION PART NUMBER Pressure Switch 46273100 Post Purge Timer 46282800 Wire Harness 46457200 Page 5
PAGE 6
INSTALLATION INFORMATION CK-41P MODEL NO.:____________________________________________________________ INSTALLER'S NAME:_____________________________________________________ INSTALLER'S COMPANY: _________________________________________________ INSTALLER'S PHONE NO.
PAGE 7
Page 7
PAGE 8
P/N 46457800 Rev B 06/04 Page 8