Install Instructions

WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage

or blindness.Never operate the UV-Aire

™

Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands.

Page 10 of 12

P/N 46648100 09/18 Rev J

TROUBLESHOOTING GUIDE

1. Do not wire the 24V models into the appliance 24 volt fan or thermostat circuit. This will cause premature

ballast or lamp failure and void the warranty. For proper operation, 24V models requires 24VAC at all

times.

2. Check to make sure 24VAC power is available at the transformer, or 120V at the electrical outlet.

3. If lamp does not light up, pull back metal washer on mounting base. If lamp comes on, the base needs

tightening to ensure that the safety switch is fully engaged.

4. If lamp does not light up, remove the ballast from the base and re-install it onto the base, ensuring that the

ﬁ nger projecting from the base engages into the safety switch slot in the ballast. Repeat step 3.

5. If lamp does not light up after performing Steps 3 and 4, replace lamp.

6. If unit still does not light up after replacing lamp, replace unit.