Instructions / Assembly

ManualsBrandsField Controls ManualsHeater AccessoriesControl Kit - Oil For SWG Power Venter

2630 Airport Road · Kinston, NC 28504

Phone: 252-522-3031· Fax: 252-522-0214

www.fieldcontrols.com

120 VAC SYSTEM CONTROL KIT

Model: CK-61

Designed for use on SWG Series Power Vent Hoods for controlling oil fired heating

appliances with 120 VAC controls.

TEMS INCLUDED IN KIT:

1) Junction box with mounted pressure switch and solid state post purge control

1) 2 Ft. Length of 1/4 inch aluminum tubing

1) 1/4 inch tubing connector

1) Flexible conduit connector

1) WMO-1 Secondary Safety Switch

This device MUST be installed by a qualified agency in accordance with the manufacturers installation

instructions.

The definition of a qualified agency is: any individual, firm, corporation or company which either in person or through a representative is

engaged in, and is responsible for, the installation and operation of gas appliances, who is experienced in such work, familiar with all

the precautions required, and has complied with the requirements of the authority having jurisdiction.

DO NOT DESTROY

THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT

Summary of content (8 pages)

PAGE 1
20 VAC SYSTEM CONTROL KIT Model: CK-61 Designed for use on SWG Series Power Vent Hoods for controlling oil fired heating appliances with 120 VAC controls. ITEMS INCLUDED IN KIT: 1) Junction box with mounted pressure switch and solid state post purge control 1) 2 Ft.
PAGE 2
INSTALLATION MOUNTING JUNCTION BOX The junction box can be mounted at the venter or remotely mounted away from the venter. (See Figure 1 & Figure 2) 1. Remove one of the knockouts from the side of the junction box where the pressure switch is mounted. Install the flexible conduit connector onto the CK-61 Junction Box and secure with fastening nut. If remote mounting the CK-61 Junction Box, mount the flexible conduit connector onto a 2" x 4" installer supplied junction box. 2.
PAGE 3
WIRING INSTRUCTIONS Wire the venter motor and controls in accordance with the National Electrical Code, manufacturer's recommendations and/or applicable local codes. UNIT MUST BE GROUNDED. Check ground circuit to make certain that the unit has been properly grounded. The wiring should be protected by an over current circuit device rated at 15 amperes. Caution must be taken to ensure that the wiring does not come into contact with any heat source.
PAGE 4
Diagram C – Typical Wiring for Oil Fired Warm Air Furnace with a Honeywell ST9103 Control Board Diagram D – Riello Burner Application Page 4
PAGE 5
Diagram E – Multiple Oil Fired Systems Page 5
PAGE 6
ADJUSTMENTS PRESSURE SWITCH ADJUSTMENTS With the venter air flow set and the appliance operating at the best operating efficiency, adjust the pressure switch by rotating the adjustment screw clockwise until the burner shuts off, then rotate the adjustment screw counterclockwise until the burner fires. Rotate the adjustment screw an additional 1/4 turn counterclockwise to ensure proper switch setting.
PAGE 7
SYSTEM CONTROL CHECK OUT PROCEDURES 1. Adjust the thermostat to call for heat and observe the power venting system for proper sequence of operation: (Repeat if necessary). 1. Thermostat calls for heat. 2. Relay is energized, post purge timer is energized, and venter motor starts. 3. Pressure switch closes and burner starts. 4. Thermostat is satisfied, relay is de-energized, burner stops and post purge timer operates venter motor for approximately 3 to 5 minutes. 2.
PAGE 8
INSTALLATION INFORMATION CK-61 MODEL NO.: _____________________________________________________ INSTALLER'S NAME: ______________________________________________ INSTALLER'S COMPANY: __________________________________________ INSTALLER'S PHONE NO.