Specification

Technical Service: 800.742.8368 • fieldcontrols.com 71
Wiring
Wiring Diagrams
For CAS with Sensors
CAS-4mV Controlled by C-Sensor, 24 Volt Application
CAS-4mV Controlled by P-Sensor, 24 Volt Application
CAS-4mV CONTROLLED BY C-SENSOR, 24VAC
(FC P/N: 601010100)
TVS
CAS-4mV
C-SENSOR
(FC P/N 46676600)
B
A
White
Black
Green
GND
GND
T4T3T2T1
Transient suppressor (FC P/N: 601010100) should
be installed directly onto the C-Sensor terminals.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.
TO APPLIANCE
L1
CAS-4mV
(FC P/N 46679400)
White
Black
Green
GND
GND
T4T3T2T1
COM N.O.
P-SENSOR
CAS-4mV CONTROLLED BY P-SENSOR, 24VAC
IMPORTANT: If using the quick connect crimp terminals
supplied with the P-Sensor, use stranded wire only. Do
not crimp terminals with the solid copper wire.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.