Specification

Wiring
Wiring Diagrams
72 Customer Service: 252.522.3031
For CAS with Sensors
CAS-4 Controlled by P-Sensor, 24 Volt Application
CAS-4 Controlled by C-Sensor, 24 Volt Application
CAS-4 CONTROLLED BY C-SENSOR, 24VAC
(FC P/N: 601010100)
TVS
120VAC / 24VAC*
CAS-4
GND
GND
C-SENSOR
(FC P/N 46676600)
WHT
BLK
R
C
White
Black
Green
*24VAC transformer will have a minimum of 20VA,
not to exceed 40VA. Class 2 type may be used.
Transient suppressor (FC P/N: 601010100) should
be installed directly onto the C-Sensor terminals.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.
TO APPLIANCE
L1
B
A
CAS-4 CONTROLLED BY P-SENSOR, 24VAC
COM N.O.
120VAC / 24VAC*
CAS-4
GND
GND
P-SENSOR
(FC P/N 46679400)
WHT
BLK
R
C
White
Black
Green
*24VAC transformer will have a minimum of 20VA,
not to exceed 40VA. Class 2 type may be used.
IMPORTANT: If using the quick connect crimp
terminals supplied with the P-Sensor, use stranded
wire only. Do not crimp terminals with the solid
copper wire.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.
WIRING INSTRUCTIONS: MUST be installed by a Certified Electrician. Wire the CAS unit in accordance with the National Electric Code
and applicable local codes. UNIT MUST BE GROUNDED. Check the ground circuit to make certain that the unit has been properly
grounded. The wiring should be protected by an over-current circuit device rated at 15 amperes. CAUTION must be taken to ensure that
the wiring does not come in contact with any heat source. All line voltage and control circuits between the CAS unit and the appliance
MUST be wired in accordance with the National Electrical Code for Class I wiring or equivalent.