Brochure

page 6
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands.
Figure 16
Figure 15
Figure 14
Figure 12
Figure 13
Remove base unit and cover from box.3.
Apply supplied Duct Seal Kit according to instructions included in kit. 4.
(SeeFigure12)
Determinewhethertouseatorangledbracket.(RefertoBulb5.
MountingBracketSelection)
Flat Bracket Installationa.
  i.Removethetwohexnutsandatbracketfromincludedbagged
hardware.
  ii.Installtheatbracketandsecuretotheunitbasewiththehex
  nutsprovided.(SeeFigure13)
Angled Bracket Installationb.
NOTE: For angled bracket mounting, refer to specifications outlined
byChartsA&BformountingdistancesintheAngledLampMounting
Bracket Specifications.
i. Remove the two hex nuts and angled bracket from included
bagged hardware.
ii. Install the angled bracket and secure to the unit base with the
  hexnutsprovided.(SeeFigure14)
NOTE: Be sure to note location of lamp hole in bracket relative to unit
base.
Mount the unit base to the duct using the four mounting screws 6.
provided.(SeeFigure15)
Remove tag and alcohol wipe from lamp. Wipe off lamp being sure 7.
not to touch lamp with bare hands. The oils in your hands cause a
reduction in lamp output.
Insert lamp through the hole until lamp cannot be inserted any further. 8.
(SeeFigure16)