Brochure

page7
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands.
Swing the swivel bracket over the end of lamp. Hand-tighten the 9.
wing nut on the stud. Be careful not to over tighten the wing nut. The
porcelain at the lamp base may crack when over tightened.
(SeeFigure17)
Plugballastplugintoendoflamp.(SeeFigure18)10.
Snapcoverontotheunitbase.(SeeFigure19)11.
PlugtheLEDwirefromthecoverontotheboard.(SeeFigure20)12.
Closethecoverandtightencoverscrew.(SeeFigure21)13.
Plug the power cord into a standard electrical outlet.14.
NOTE: Seal the joints and seams of the plenum near the mounting location
toreduceanydirectviewingoflight.(SeeFigure1)
PressthepowerswitchtotheONposition.(Lightonswitchshouldbe15.
on,indicatingpower.)
Look through view port in the box cover to be sure the lamp is working. 16.
Youshouldseeablueglow.(Theviewportiscoveredwithaplastic
lensthatblockstheUVCrays.)Ifequipped,theLEDlightwillshowa
continuous GREEN color indicating proper unit operation.
If the lamp is not glowing, follow steps 8-14 again. If lamp still does 17.
notglow,contacttechnicalsupportat252-522-3031forfurther
assistance.
Figure 21
Figure 20
Figure 19
Figure 18
Figure 17