Installation Guide

ManualsBrandsFIELD ManualsHeating, Ventilation, and Air Conditioning6 in. Damper with Collar

www.ﬁeldcontrols.com

Please retain these instructions after installation.

This device MUST be installed by a qualiﬁed agency in accordance with the manufacturer's installation instructions. The deﬁnition of

a qualiﬁed agency is: any individual, ﬁrm, corporation or company which either in person or through a representative is engaged

in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the

precautions required, and has complied with all the requirements of the authority having jurisdiction.

READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.

Installation Date:

Installed By: Phone:

BAROMETRIC DRAFT CONTROLS

Model: 4"-7" RC

ITEMS INCLUDED:

Barometric Draft Control

WHEN SHIPPED WITH A COLLAR ADDITIONAL ITEMS:

Mounting straps, Collar, Mounting Hardware

WARNING: Read the installation instructions carefully and completely before proceeding with the installation.

Summary of content (4 pages)

PAGE 1
BAROMETRIC DRAFT CONTROLS Model: 4"-7" RC WARNING: Read the installation instructions carefully and completely before proceeding with the installation. ITEMS INCLUDED: Barometric Draft Control WHEN SHIPPED WITH A COLLAR ADDITIONAL ITEMS: Mounting straps, Collar, Mounting Hardware READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION. This device MUST be installed by a qualified agency in accordance with the manufacturer's installation instructions.
PAGE 2
BAROMETRIC DRAFT CONTROLS WITH OR WITHOUT COLLAR The Field RC is furnished as standard equipment on many leading brands of oil fired heating equipment. It is calibrated to allow for easy adjustment to the furnace or boiler manufacturer’s specifications. Designed for draft settings from .02” to 08” of W.C. CONTROL LOCATIONS The control should be located as close as possible to a furnace or boiler and positioned as shown in Figure 1.
PAGE 3
INSTALLATION AND ADJUSTMENT NOTE: See sections on control locations and collar installation. Insert the draft control into the collar. The front face of the control must be plumb. The pivot points must be level whether the control is on a horizontal, vertical, or sloping flue pipe. Use a spirit level, plumb and level accurately. Secure the control in the collar by tightening the clamping screws.
PAGE 4
LIMITED WARRANTY Field Controls, LLC (“Company”) warrants that its products shall be free from defects in material and workmanship under normal use for the limited period indicated, from the date of manufacture, subject to the provisions 1-8 below. Eighteen (18) months All Field Controls Products (except for those listed below as 5 years or 90 days). Five (5) years Field Controls Direct Vent Systems (FDVS), Field Oil Vent Kits (FOVP), and ComboVents (CV).