Instruction Manual

EN 8
FZS 3020-B
Operating instructions
Safety instructions
Cutting tools
When installing the cutting tool, check the condition of the blade. If it is damaged (cracked, bent, broken off,
etc.), replace it.
After installing the blade, check again that the hole in the blade is level with the arm of the blade tang.
Spin the blade, check again that the blade has no tendency to rotate irregularly.
Check that the blade is installed with the sharp edge moving in the direction of rotation. Never install it the
other way around.
Check that the cutting tool is properly assembled by turning it without load (1 minute is enough).
An appropriate blade must be selected for the material that is to be cut.
Never push the blade against objects when in operation. Material must be cut at reasonable speed.
If you hear an unusual noise or the machine vibrates abnormally, stop working and identify the cause.
Do not stop the machine while the blade is cutting a material. There is a danger of damaging the machine.
The cutting tool must be fi tted with an appropriate guard.
ATTENTION! If instructions are not followed, there is a danger of a serious or even fatal
Injury to persons!
Acquaint all persons working with this machine with the operation of the machine and the safety
instructions.