Operator's Manual
54
Safety Information
Only qualified personnel trained in service
and installation of electric heaters, boilers, and
furnaces shall use this combustion analyzer.
This device measures and analyzes key
parameters of combustion equipment including
oxygen, carbon monoxide, temperature, carbon
dioxide, eciency, and draft pressure.
Read and understand this operator’s manual
in its entirety before using to prevent injury
or damage to you or the equipment. As with
any job, appropriate use of personal protective
equipment (PPE) is required.
!
WARNING
• Do not use the analyzer as a safety device.
• Always be aware of and test for ambient CO levels.
• Do not use unless in a well-ventilated location.
• Do not use in areas classied as hazardous locations; not
intrinsically safe.
• Do not use unless a visual inspection ensures it’s safe to do so.
• Ensure any connections to fuel sources are leak-free.
• Do not touch or store probe until it cools to ambient
temperature.
• Condensate may be acidic.
• Combustion gases may be toxic even in low concentrations.
• Seal any equipment holes used during testing in order to
prevent dangerous ue gas entering the space.
!
CAUTION
• Do not use or store near solvents.
• Do not clean with solvents.
• Do not use on a continuous basis.
• Refer to 3rd party smoke test documentation to verify if smoke
in equipment is at a safe level (1 or less). Not verifying this prior
to conducting other tests, such as combustion, can result in
damage of the analyzer and produce incorrect measurements.
• This device should only be opened and/or serviced by
authorized personnel. Gas sensors may be replaced by user.
• Do not disconnect combustion probe cable when powered on.
• Use only within operating environment specication.
• Do not use in the rain or wet environments.