Instructions / Assembly
7
Installation (continued)
6
Installation (continued)
5
Securing the canopy
Care and cleaning
Troubleshooting
The xture will not light.
Problem Possible cause Solution
The power is off.
The circuit breaker is off.
Ensure the power supply is On.
Ensure the circuit breaker is in the On position.
The fuse blows or the circuit breaker
trips when the light is turned on.
The wires are crossed or the power wire
is grounding out.
Check the wire connections.Contact a qualied
electrician or call the Customer Service Team at
1-800-986-3460.
□ Clean the xture with a soft,dry cloth.
□ Do not use any cleaners with chemicals,solvents or hash abrasives.
CAUTION: Before attempting to clean the xture,disconnect the
power to the xture by turning the breaker off or removing the fuse
from the fuse box.
4
Securing the ying ring
□ Screw the ying ring (A) onto the xture (B).
□ Tighten ring (DD) onto screw collar loop (CC) to secure
canopy (FF) over cross bar (AA).
□ Open the bottom section of the chain (EE) and attach it to the
ying ring (A).
AA
CC
FF
DD
EE
A
B
B
C
D
E
F
G
A
7
Changing the lamp shade
If new lamp shade (not included) is desired to replace.
□
□
□
Unscrew knobs (G), then take stems (F), bottom ring (E),
lamp shade (D) and top ring (C) down.
Put top ring (C) on the new lamp shade (not included) and
then put them onto the bottom ring (E).
Install back bottom ring (E) and stems (F) to xture (B)
by securing knobs(G).
6
Installing the bulbs
□ Screw the bulbs (not included) into the sockets.
NOTE: Use ve 60-watt max. candelabra base bulbs or ve
candelabra base CFL equivalent bulbs.