User's Manual

Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for
help.
Specific Absorption Rate (SAR) information
The SAR limit of USA (FCC) is 1.6 W/kg veraged over one gram
of tissue. Device types LTE Flip Phone (2) (FCC ID: 2ADX3T2)
has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at
the body is 0.569W/kg.Head SAR is 0.737W/Kg,Highest Reported
simultaneous SAR Summary 0.663W/Kg. This device was tested
for typical body-worn operations with the back of the handset kept
10mm from the body. To maintain compliance with FCC RF
exposure requirements, use accessories that maintain a 10mm
separation distance between the user's body and the back of the
handset. The use of belt clips, holsters and similar accessories
should not contain metallic components in its assembly.The use of
accessories that do not satisfy these requirements may not comply
with FCC RF exposure requirements, and should be avoided
16