Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS FOR ITEM
#180-6#181-6#182-6
NOTE : Should any difficulty be experienced, please consult a qualified electrician
before installing.
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
WARNING :
INSTALLATION STEP:
1. Turn off the electricity at the Fuse
or Circuit Breaker before installation.
2. Attach the Cross Bar to the Outlet
Box by the 2pcs Mounting
Screw-2 upwards.
3. Decide the amount of Pole sections needed
for the desired height and attached those Pole
sections together, run the wire from the fixture
through the Pope sections and Swivel
into the Canopy, attached one end of Pole
section to the Bottom Nipple and the other
end to the Swivel and secure the Swivel
With the Fixing Nut through the Flat Iron
and Canopy.
4. Make wire connection with Wire
Connectors:
----Connect the black Wire from
the light to the Black Wire from
the Outlet Box.
----Connect the white Wire from the
light to the White Wire from the Outlet Box.
----Attached the Ground Wire and House Ground Wire to the Cross Bar with a Green Screw.
Carefully tuck wires back into the Outlet Box.
5 Carefully attached the Glass to the Socket, if the Glass is not fix the Bobeche in one side
please try another side and Install Bulbs. (Bulbs are not included, please
do not exceed the maximum capacity which is recommended on the Bobeche.)
6. Raise up the fixture and insert the NIpple into the Canopy and tighten with the Fixing Nut.
7. Turn on the power at Fuse or Circuit Box and enjoy your new fixture.