User's Manual

How to Connect
◆Selecting Connection Methods
Wired Connection Wireless Connection
A B C
USB
Connection
Battery
Power
Bluetooth
Connection
Bluetooth
Connection
USB
Power
◆Connect to Personal Computer Via Cable
USB Connection (As per diagram A)
May perform connection by using the USB cable supplied with this product. In using Bluetooth, press USB connection toggle
button on the right, LED indicator of the button will flash and it will switch to USB connection. USB mouse, etc. can be
connected through USB Through port for use only when USB is connected.
(Does not have recharging function for Ni-MN Rechargeable Batteries.)
◆
Connect to Personal Computer Via Wireless
Bluetooth Connection (As per diagram B)
Using a Bluetooth adapter or a device embedded with Bluetooth function for the connection setup (pairing function), hence
connecting to the personal computer.
This product does not include a Bluetooth adapter. Therefore, one must be purchased from the retail market, and after
installing the Bluetooth adapter, connection setup may then be performed. When the personal computer has an embedded
Bluetooth function, please enable the Bluetooth function.
Bluetooth Connection and USB Power (As per diagram C)
When USB is connected, press Bluetooth device registration button, then Bluetooth will be connected and USB will feed
power.
[Procedure 1] Turn on the keyboard
Battery cover
◆
Installing Bluetooth Device
The following is the operating method of genuine OS software or drive program setting. Please refer to the Bluetooth receiver
instruction manual when setting with the special software attached to the Bluetooth receiver.
Open the battery case on the back of the keyboard and put in batteries in accordance with correct direction of electrode and
then set the power switch of Bluetooth at ON.
[Procedure 2] Installing Bluetooth Device (Pairing Mode)
Long press any of the 󰴤󰴧 Bluetooth device registration
buttons for at least 2 seconds, then enter pairing mode.
The mode will end after maintaining the status for around
three minutes. To end forcibly, click the flashing target button,
then LED indicator will not flash any more, and the mode will
end.
Remove battery cover,
insert two AA batteries.
Turn on the power switch
4.
5.
Windows 7 / 8 / 8.1 / 10
1. Open the Control Panel.
2. On category view, click [Hardware and Sound], then click [Add a device].
On icon view, click [Devices and Printers]
,
then click [Add a device
]
.
3. Open the [Add Bluetooth Device Wizard].
Add a device window displays [Select a device to add to this computer.]
4. Bluetooth devices found.
Select [Majestouch Convertible 3], then click [Next].
5. Add device passcode.
When the passcode dialog box appears, select [Create a pairing code for me]
then click [Next]. (Windows 7)
* Win10 will not show
Majestouch Convertible 3
: flash : not lit
Bluetooth Connection LED Lit Modes
Indicator for Low Power
• When the remaining power in the battery is insufficient
Pairing mode
• Long press any of the
󰴤󰴧 Bluetooth device registration buttons of
the target device to be registered for at least 2 seconds;
* Please complete registration within 3 minutes;
* Please press the button again to cancel.
Device switching mode
• Press the Bluetooth device registration button of the device to be
switched for registration.
Pairing setup mode
• Find the device and start pairing operation.
Stop flashing
The button long pressed
flashes in blue
for 3 minutes.
The button pressed
flashes 3 times.
Blue
Blue
Low Power Indicator LED
flashes
Red
Mode • Operation
LED Lit Mode
 