Portable Air Purifiers READ AND SAVE THESE INSTRUCTIONS INSTALL PRE-FILTER BEFORE USE PRE-FILTER I II ER III O PRE-FILT A FILTER HEP I II FILTER PRE III 0 A FILTER HEP I II FILTER PRE III 0 A FI HEP Owner’s Guide For Model Series 50100 • 50150 • 50200 • 50250 • 50300 Air Cleaners The Science of Clean Air®
IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS AIR CLEANER When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Read all instructions before operating the air cleaner. Place air cleaner where it is not easily knocked over by persons in the household.
Congratulations You now own a quality portable HEPA air cleaner that has been engineered and crafted for your satisfaction. For Best Performance We recommend that you operate your Honeywell air cleaner 24 hours a day because indoor air can be quickly contaminated by activity in a room, infiltration of outside air, and from other sources of contamination.
Operation LOCATE PRE-FILTER IN THE BOX AND INSTALL BEFORE INITIAL OPERATION. Refer to “How to Change the Filters” section for proper installation. Model 50100 Series The Honeywell Model 50100 is a 3 speed air cleaner operated by moving the speed control knob on the top panel from the Off (O) position to the High position.
Filter Replacement Caution: Do not attempt to wash either the carbon pre-filter or the HEPA filter. They are not washable and washing will damage the filters. With proper maintenance, your Honeywell air cleaner is designed to provide years of high efficiency air cleaning. Our recommendations regarding filter replacement intervals are intended as guidelines only, as life expectancy of any filter media is dependent on the concentration of the contaminants to which the system is exposed.
The Intelli-Check™ Filter Monitors will indicate replacement of the pre-filter and the HEPA filter. Depending upon your individual usage (environment and hours used), you may need to check and replace the filters more or less frequently. To check Expected Filter Life Usage When the unit is turned on, quickly press the appropriate filter monitor button. The pre-filter light will flash up to 3 times and the HEPA filter light will flash up to 4 times, depending upon how much expected filter life has been used.
How to Change the Filters CAUTION: DISCONNECT FROM POWER SUPPLY BEFORE SERVICING Do not attempt to wash either the carbon pre-filter or the HEPA filter. They are not washable and washing will damage the filters. The only two parts requiring any service are the carbon pre-filter and the HEPA filter. No tools are needed. To change either filter, disassemble the unit as shown below: Step 1: Turn the air cleaner off and unplug from the wall outlet.
Troubleshooting • • • • • • Start on HIGH for a few minutes, then adjust to desired speed. This product may emit a “new” smell which will disappear over a relatively short period of operation. Check to make sure that the power cord is correctly connected to the outlet. Test that the outlet is functioning properly using another appliance or lamp. Check the fuse or circuit breaker. The outlet may be overloaded if other appliances are also in use. Determine and correct the cause of the overload.
E. Return defective product to the following address with a brief description of the problem. Include proof-of-purchase and a U.S. $10.00/ Canadian $15.00 check or money order for handling, return packing and shipping charges. Please include your name, address and daytime phone number. You must prepay shipping charges. Mark carton “Attention Returns Department” Ship to: In USA: Honeywell Returns Department 4755 Southpoint Drive Memphis, TN 38118 U.S.A. In Canada: Honeywell 510 Bronte St.
