User Guide

Page 8 AirTamer®

Insert the 6. AIR FILTER by placing the bottom

of the AIR FILTER inside your AirTamer and

pushing it past the large front rubber tab.

Then push the top of the AIR FILTER past the

large front rubber tab at the top of the unit.

NOTE:

make sure ThaT The air floW arroWs oN The filTer

face ToWards The froNT of The uNiT.

Replacethe7. AIR EXIT GRILL.

Place the unit on a level oor, keeping it 8.

at least 4” (10.2 cm) away from any wall,

furniture or appliances. Position the unit so

that the clean air will ow to your desired

area (clean air ows from the front of the

unit). Ensure that the AIR INTAKE GRILL

and AIR EXIT GRILL are not blocked.

Power On/Off

The 1. POWER CORD is shipped as two pieces.

Connectthetwopieces,plugtheendwith

wall outlet prongs into an electrical outlet,

and the round end into the POWER JACK

located at the back of your AirTamer®.

Press the 2. POWER BUTTON to turn the unit

on. The POWER BUTTON will illuminate

when on.

Fan Speed

Your unit will initially start at the highest speed – Speed 5. Select your

desired fan speed by pressing the corresponding SPEED BUTTON.

Your AirTamer® has ve (5) SPEED SETTINGS 1, 2, 3, 4, and 5.

SPEED 5

will provide the highest rate of cleaning performance, but more noise.

SPEED 1

will provide the least amount of noise, but a slower rate of cleaning.

Normally,thelowerspeedsareidealforsleeporrelaxationenvironments.

HW_A600_UserMan_ENG_09.indd 8 5/11/09 2:25:04 PM