Full Product Manual

ManualsBrandsFIMCO ManualsBattery Sprayers30 Gal. Boom/Handgun Tow Behind Tank Sprayer

Page 1

Model: LG-30-TRL (5302317)

(30 Gallon Lawn & Garden Trailer Sprayer)

www.fimcoindustries.com

1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049

Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440

[5194822 (02/20)]

Technical Specifications

 30 Gal. Corrosion-Resistant Polyethylene Tank

 12 Volt Diaphragm Pump, 2.4 GPM - 60 PSI

 15 Ft. Handgun Hose

 25 Ft. max. vertical throw, 40 Ft. horizontal throw

 2-Nozzle Break-Away Boom Assembly (80” Spray Coverage)

 Corrosion-Resistant Nylon Nozzles

 Check Valve Strainers, 50 Mesh, 5 PSI

 Easy access drainage port (Complete Drain Out)

 Front forward gun and hose wrap for easier access from

transport vehicle

 Heavy Duty 16” tires

 Wide Axle

 Streamlined tank design for compact storage and

shorter turning radius

Caution: Always check the vehicle load rating before using

the sprayer. The loaded weight of this sprayer and boom

assembly is approx.: 320 lbs. when the tank is full.

Assembly Instructions

 Make sure the contents of the sprayers carton match the

items shown on page 2 of the manual.

 Follow the steps on pages 3 & 4 to properly assemble the

sprayer.

IMPORTANT:

This sprayer comes with

an On/Off (shut-off) valve

located at the inlet location

of the tank, towards the

underside. You must make

sure the valve is in the

“open” position before

using your sprayer.

OWNER’S MANUAL

BEFORE RETURNING THIS PRODUCT

FOR ANY REASON, PLEASE CALL

1-800-831-0027

MONDAY-FRIDAY, 8:00 AM TO 5:00 PM CST

If you should have a question or experience a problem with

your Fimco Industries Product: Visit our website @

www.fimcoindustries.com or call the Toll free number above. Our

technical support representatives will be happy to help you.

In most cases a customer service rep. can resolve

the problem over the phone.

To obtain prompt, efficient service, always remember to give the

following information....

• Correct Part Description and/or part number

• Model number and Serial Number

Part descriptions and numbers can be obtained from the

illustrated parts list section(s) of this manual.

General Information

Thank you for purchasing this product. The purpose of this

manual is to assist you in operating and maintaining your lawn

& garden Trailer sprayer.

Retain a copy of your receipt for your

unit, as it will be required to validate

any warranty service.

Warranted against manufacturer or

workmanship defects from date of

purchase with copy of receipt:

Homeowner Usage: Sprayer-One Year and Pump-Two Years.

Commercial Usage: Sprayer and Pump-90 Days.

Summary of content (12 pages)

PAGE 1
OWNER’S MANUAL Model: LG-30-TRL (5302317) (30 Gallon Lawn & Garden Trailer Sprayer)          General Information Thank you for purchasing this product. The purpose of this manual is to assist you in operating and maintaining your lawn & garden Trailer sprayer. Technical Specifications 30 Gal. Corrosion-Resistant Polyethylene Tank 12 Volt Diaphragm Pump, 2.4 GPM - 60 PSI 15 Ft. Handgun Hose 25 Ft. max. vertical throw, 40 Ft.
PAGE 2
Contents of your sprayer’s carton (LG-30-TRL) Tank/Plumbing Pre-Assembly Owner’s Manual Tongue Assembly Tires Contents of Parts Bag (#5278364) Breakaway Boom Bracket Kit LG-30-TRL (#5278366) Page 2
PAGE 3
Your tank comes pre-assembled with the pump, manifold, bypass, intake assembly, lid w/lanyard, handgun, handgun hose, handgun hose quick connect and loom clamp already attached. Detail A To assemble the tongue and frame to the tank. Locate the (4) 5/16” x 5/8” Flange Lock Screws, (2) 5/16” x 2-1/4” Flanged bolts, tank support, axle support and the preassembled tongue . Turn the tank upside down. Detail A: Loosely attach the tank support and axle support with (4) lock screws.
PAGE 4
Break-Away Boom Assembly is preassembled. Follow the directions below to mount to your tank. Detail A Detail A: Locate the (2) Boom Top Straps and then in the parts bag, locate (2) 5/16-18 x 5/8” Flanged Lock Screws. Attach the Boom Top Straps to the tank, using the two screws. DO NOT TIGHTEN Detail B: Locate the Boom Assembly and then in the parts bag, locate (2) 5/16-18 x 5/8” Flanged Lock Screws. Attach the Boom Assembly to the tank, using the two screws.
PAGE 5
IMPORTANT: Remove tank lid and be sure the tank is clean and free of any foreign material. Rinse tank out of any tank residue before filling with water to test. Manifold Valves CLOSED Testing the Sprayer NOTE: It is VERY important for you to test your sprayer with plain water before actual spraying is attempted. This will enable you to check the sprayer for leaks without the possibility of losing any expensive chemicals.
PAGE 6
Tip Chart for TKT-VP3, TF-VP3 & 30DT3.0 Tips Speed Chart Tip No. Time Required in seconds Speed in M.P.H. (Miles Per Hour) 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0 10.0 100 Ft. 68 sec. 34 23 17 14 11 9.7 8.5 7.6 6.8 200 Ft. 136 sec. 68 45 34 27 23 19 17 15 14 (Color) 300 Ft. 205 sec. 102 68 51 41 34 29 26 23 20 3 (Gray) Tip No. (Color) 3 (Gray) Tip No. (Color) 3 (Gray) Using the Boom Nozzles Four things must be considered before spraying with the boom.  How much chemical must be mixed in the tank.
PAGE 7
Pump Model: 5281371 2.4 GPM, 60 PSI Available Replacement Parts Replacement Pump: 5151087 Includes: 1/2” MNPT Port Kit Fitting #5168832 1/2” Hose Barb Port Kit Fitting #5168833 3/8” Hose Barb Port Kit Fitting #5168836 DO  Clean and rinse your pump after each use with Fimco Tank Neutralizer  Winterize your pump or sprayer by rinsing, draining and running RV Antifreeze through it before storing for the winter.  Use clean water for your spray mixture  Store inside a building when not in use.
PAGE 8
Checking the Pressure Switch: If your motor is not running and you’ve checked the following: for loose wiring connections, fuse, the switch on the lead wire was “ON” and made sure you were connected to a fully charged battery and everything is fine, but the motor won’t run, then it’s time to check to see if the pressure switch is bad.  Remove the cover off the 1” square box (pressure switch) on the head of the pump, the cover is held on by one phillips-head screw. This will expose the two red wires.
PAGE 9
See Boom Assembly Parts List Next Page See Manifold Assembly Detail Page 11 See Intake Assembly Detail Page 11 Exploded View/Parts List: LG-30-TRL (5302317) Page 9
PAGE 10
Exploded View Parts List: Boom Assembly (5281003) Hinge Detail Opposite side has typical setup Based on the minimum overlap required to obtain uniform distribution with 120° tips and 40” spacing. Suggested Minimum Spray Height: 18”-20” above what is being sprayed (to plant, not ground). Optimum Spray Height: 39” Wide angle spray nozzle height is influenced by nozzle orientation. The critical factor is to achieve a minimum 30% overlap.
PAGE 11
Intake Assembly 5278143 Manifold Assembly 5281537 This sprayer comes with an On/Off (shut-off) valve located at the inlet location of the tank, towards the underside. You must make sure the valve is in the “open” position before using your sprayer.
PAGE 12
Warranty LIMITED WARRANTY FOR NEW FIMCO, IND. EQUIPMENT WHO MAY USE THIS LIMITED WARRANTY. This limited warranty (the “Limited Warranty”) is provided by Fimco, Ind. to the original purchaser (“you”) of the Equipment (as defined below) from Fimco, Ind. or one of Fimco, Ind.’s authorized dealers. This Limited Warranty does not apply to any subsequent owner or other transferee of the Equipment.