Datasheet
16
12 SERIES
Time switches 16 A
12
SERIES
J
VII-2023, www.findernet.com
Outline drawings
Types 12.62 / 12.A2 / 12.A4
Screw terminal
Type 12.B2
Screw terminal
Battery replacement type 12.51, 12.61, 12.62, 12.81, 12.A1, 12.A2, 12.A4, 12.B2
Power-save mode
If the 230VAC supply is not connected, the time switch enters power-save mode: only the clock is
maintained active whilst the display turns off so as to guarantee a long life for the built-in back-up battery.
With a press to the joystick it is possible to “awake” the device and enter Display mode (with the “plug” symbol
displayed). A further press to
will enter the program or set-up mode as explained in the Display mode
section above.
After about 1 minute of inactivity the power-save mode will start again. During program or set-up the current
absorption is higher than in power-save mode, thus influencing the battery life.
In this mode the display back-light is not active. It is activated following a press to the joystick only with the
230VAC supply connected, but after about 1 minute of inactivity the display back-light will turn off, and to
activate it again it is necessary to press the joystick again.
Note: the output relay only functions if the power supply is connected.