Datasheet

ManualsBrandsFINDER ManualsRelays13.31.8.230.4300

VI-2015, www.findernet.com

SERIES

13 SERIES

Electronic step relays 10 - 16A

13.81 - Electronic step relay - Rail mount - 1 Pole

13.91 - Electronic step relay and timing step relay

Switch box mount - 1 Pole

• Fixed time (10minutes) timing function

selectable (13.91)

• Use with 3 or 4 wire connection, with automatic

recognition by the relay

• Control input can be continuously applied

• Longer mechanical and electrical life, and much

quieter than electromechanical step relays

• “Zero crossing” load switching

• Can be mounted behind blanking plates, as

widely used in residential wiring systems such

as; BTicino: Axolute, Matix, Living and Magic,

Gewiss: GW24, Vimar: Plana and Idea…(13.91)

• 35mm rail (EN60715) mount (13.81)

• Cadmium free contact material

13.81/91

Screw terminals

13.81 13.91

• 1 NO (SPST-NO)

• 35mm rail (EN60715) mount

• 17.5mm wide

• 1 NO (SPST-NO)

• Step relay and timing step

relay (10minutes)

• For mounting within

residential switch boxes

For outline drawing see page 10

Contact specification

Contact configuration 1 NO (SPST-NO) 1 NO (SPST-NO)

Rated current/Maximum peak current A 16/30 (120 - 5ms) 16/20 (80 - 5ms)

Rated voltage/

Maximum switching voltage VAC 230/— 230/—

Rated load AC1 VA 3700 2300

Rated load AC15 (230VAC) VA 750 450

Nominal lamp rating:

230V incandescent/halogen W 3000 1000

fluorescent tubes with

electronic ballast W 1500 500

fluorescent tubes with

electromechanical ballast W 1000 350

CFL W 600 300

230V LED W 600 300

LV halogen or LED with

electronic ballast W 600 300

LV halogen or LED with

electromechanical ballast W 1500 500

Minimum switching load mW (V/mA) 1000 (10/10) 1000 (10/10)

Standard contact material AgSnO

AgSnO

Supply specification

Nominal voltage (U

) VAC (50/60Hz) 230 230

VDC — —

Rated power VA (50Hz)/W 3/1.2 2/1

Operating range AC (50Hz) (0.8…1.1)U

(0.8…1.1)U

DC — —

Technical data

Electrical life at rated load in AC1 cycles 100·10

100·10

Maximum impulse duration continuous continuous

Dielectric strength between: open contacts VAC 1000 1000

supply - contacts VAC — —

Ambient temperature range °C –10…+60 –10…+50

Protection category IP 20 IP 20

Approvals (according to type)

Summary of content (12 pages)

PAGE 1
3 SERIES Electronic step relays 10 - 16 A 13 SERIES 13.81 - Electronic step relay - Rail mount - 1 Pole 13.81 13.91 13.91 - Electronic step relay and timing step relay Switch box mount - 1 Pole • Fixed time (10 minutes) timing function selectable (13.
PAGE 2
13 SERIES 13 SERIES Electronic step/monostable relays 16 A 13.01 - Electronic step/monostable relay Rail mount - 1 Pole 13.61 - Multifunction step/monostable relay with reset command - Rail mount 1 Pole • Selectable Step or Monostable operation (13.01) • Multifunction (Step, Timing step, Monostable, Light ON) (13.61) • Reset feature, for centralized off command (13.61) • Set feature, for centralized on command (13.61.0.
PAGE 3
13 SERIES Electronic call/reset relays and monostable relays 8 - 12 A 13.11 - Call & Reset Relay - Rail mount - 1 Pole 13.11 13 SERIES 13.12 13.31 13.12 - Call & Reset Relay - Rail mount - 2 Pole 13.31 - Electromechanical monostable relay Switch box mount - 1 Pole • Call relay with reset command suitable for • • • residential and commercial applications: public bathroom, hospital, hotel (type 13.11/13.
PAGE 4
13 SERIES Electronic step/monostable and call/reset 13 SERIES Ordering information Example: 13 series, electronic step/monostable relay, 35 mm rail (EN 60715) mount, 1 CO (SPDT) 16 A contact, 230 V AC supply. 1 3 . 0 A B C D 1 . 8 . 2 3 0 . 0 0 0 0 Series A: Contact material 0 = Standard 5 = Standard AgSnO2 (only for 13.31) B: Contact circuit 0 = Standard 3 = Standard NO (only for 13.
PAGE 5
13 SERIES Electronic step/monostable and call/reset 13 SERIES Functions Type 13.01 Monostable On closure of a switch between terminals (B2-B3) the output contact will close, and remain so, until the switch opens. Step relay (bistable) After every impulse (B1-B2), the output contact changes state alternately switching from open to closed and vice versa. 13.11 13.12 Call and Reset relay On momentary closure of the Set switch (S), the output contact closes.
PAGE 6
13 SERIES 13 SERIES Electronic step/monostable and call/reset Functions Type 13.61.8.230 Functions (RM) Monostable On closure of a switch between terminal 3 and Line (or Neutral, in case of 3-wire connection) the output contact will close, and remain so, until the switch opens. (IT) Timing step relay On initial impulse the output contact closes and timing starts for the pre-set duration T; On expiry of the time delay, the output contact opens.
PAGE 7
13 SERIES Electronic step/monostable and call/reset 13 SERIES Wiring diagrams (13.01, 13.11, 13.12 and 13.31) Type 13.01 Step wiring diagram Type 13.01 Monostable wiring diagram Red LED indication: Continuous = relay ON Red LED indication: Continuous = relay ON Type 13.11 Call & reset relay Type 13.12 Call & reset relay Reset Reset Set Set Type 13.31 Connection VI-2015, www.findernet.
PAGE 8
13 SERIES 13 SERIES Electronic step/monostable and call/reset Wiring diagrams (13.61) Type 13.61.8.230 3 wire connection Red LED indication: Continuous = relay ON Blinking = relay OFF Type 13.61.8.230 4 wire connection Red LED indication: Continuous = relay ON Blinking = relay OFF Reset Reset Max 10 (≤ 1 mA) illuminated push buttons Type 13.61.0.
PAGE 9
13 SERIES Electronic step relays 13 SERIES Wiring diagrams (13.81 and 13.91) Type 13.81 3 wire connection Red LED indication: Continuous = relay ON Blinking = relay OFF Type 13.81 4 wire connection Red LED indication: Continuous = relay ON Blinking = relay OFF L N Max 15 (≤ 1 mA) illuminated push buttons Type 13.91 3 wire connection Max 15 (≤ 1 mA) illuminated push buttons Type 13.91 4 wire connection Max 12 (≤ 1 mA) illuminated push buttons Max 12 (≤ 1 mA) illuminated push buttons VI-2015, www.
PAGE 10
13 SERIES 13 SERIES Electronic step relays Outline drawings 13.01 Screw terminal 13.11 Screw terminal 13.12 Screw terminal 13.31/13.91 Screw terminal 13.61 Screw terminal 13.81 Screw terminal VI-2015, www.findernet.
PAGE 11
13 SERIES Electronic step relays 13 SERIES Accessories Adaptor for panel mounting, for type 13.01, 35 mm wide 011.01 Adaptor for panel mounting, for type 13.11, 13.12, 13.61 and 13.81, 17.5 mm wide 020.01 Sheet of marker tags for type, 13.11, 13.12, 13.61 and 13.81, plastic, 72 tags, 6 x 12 mm 019.01 011.01 020.01 060.72 VI-2015, www.findernet.
PAGE 12