Datasheet

G
Application example
This application example shows an LED lamp with the interconnection to a second LED lamp.
The lamps are easily connected together with plug connectors (up to max. 10 lamps).
The interlocked plug connections guarantee a secure hold and reliable electrical contact even with strong vibrations.
At cable assemblies which are different from the standard cables length, the plugs and sockets must be ordered separately.
Application instructions
LED lamps
The LED lamp in Series 7L are equipped with an ON/OFF switch or
a motion sensor and provide outstanding characteristics for use in
cabinets and housings. After opening the door of the cabinet or housing,
the electronic or electrical components are very often not immediately
recognisable due to the darkness or high packing density in the cabinet
and this makes troubleshooting much more difficult.
The light intensity of 5W LED lamp corresponds to a 95W incandescent
bulb and offers not only high brightness but also a long service life.
Electrical connection of the first lamp
The electrical connection is made with the flexible connection cable,
2x1.5mm
2
, 2.0m long, with a 2-pole connector.
Electrical connection of additional lamps in series
The connection to the additional lights uses the flexible 2 x 1.5 mm
2
connection cable, 1.0m long, with a plug and socket connected.
Connection with custom cable
Plugs and sockets are available for custom line lengths and types.
The coding for AC and DC should be noted.
Type of mounting
With magnetic fixing, the lamp can be mounted in any desired location
on a steel surface in the cabinet or housing without installation effort.
The LED lamp with the screw fixing offers through its permanent
attachment a fixed illumination of the cabinet.
By turning the LED lamp in the clip fixing, the LED lamp can be directed
exactly to the place that should be lighted. The LED lamp can also be
taken out of the clip fixing to get more exact lighting in the cabinet or
housing.
To loosen the sockets or the plug to the LED lamp is a screwdriver to use
with a blade width of 2mm.
First commissioning of lights with motion sensors
After electrically connecting the LED lamp, an automatic test program
runs to check the motion sensor. The LED lamp flashes briefly twice and
goes out again. After the motion sensor is activated again, the LED lamp
turns on for 5seconds and goes out again. The LED lamp is now ready to
use. When the motion sensor is activated, the LED lamp will stay on about
5min. The motion detection range of the motion sensor is 2m. If the LED
lamp is disconnected from the power supply and connected again, the
test sequence starts again.
Door contact switch
The door contact switch monitors the position of the cabinet door in
three different variants. Depending on the application, the NC switch
turns the lighting ON when the cabinet door is opened.
In the NO-version, the lighting can be turned ON when the cabinet door
is closed. With the CO-version, different applications can be turned ON
or OFF.
The door contact is mounted with a 21 mm slot and a wide 35 mm
adjustment range for the switch housing, so that the door contact can
be variably mounted in many different positions. The two locking levers
fasten the door contact switch so that a switching distance of 8 mm
remains.
5
VI-2015, www.findernet.com
7L
SERIES
7L Series - LED lamps